Blog – Page 3 – RolliBot

12AugAugust 12, 2015

Cleaning side brushes

Clean the side brush when it gets dirty and replace it if it is damaged. Max life span for side brush is 12 months. Note: Before replacing side brushes, check for "L" and "R" mark on side brush and match with "L" and "R" mark on bottom base of the robot.

12AugAugust 12, 2015

Cleaning Dust Bin and Filters

Empty and clean dust bin after each use. Follow the steps shown below: Cleaning dust bin and filters. NOTE: Wash HEPA filter after used for 15-30 days. Max life span for HEPA and primary filter is 24 months. Reinstall the HEPA and primary filter after they are fully dry. HEPA and primary filter could be replaced if needed. Do not dry the filters under direct sunlight.

12AugAugust 12, 2015

Error Codes for Motors

Troubleshooting - Error Codes for Motor Error Code Cause Solution L01x Fan overloaded Check if fan is covered and clean dust bin and dust filters L0x1 Left wheel overloaded Check if it is jammed or tangled by obstacle. L0x2 Right wheel overloaded Check if it is jammed or tangled by obstacle. L0x3 Left and right wheel overloaded Check if it is jammed or tangled by obstacle. L0x4 Left side brush overloaded Check if it is jammed or tangled by obstacle. L0x5 Left wheel and left side brush overloaded Check if it is jammed or tangled by obstacle. L0x6 Right wheel and left side...

12AugAugust 12, 2015

Error Code for Sensors

Troubleshooting - Error Code for Sensors RolliBot Displaying Error Code: AUBN (dust bin removed) Error Code Cause Solution AUBF Suction passage blocked Clean suction passage AUBN Dust bin not installed correctly or dust bin removed. Remove and replace the dust bin inside the robot. E1xx Left collision switch fault Check front bumper. E2xx Right collision switch fault Check front bumper. E3xx Left and right collision switch fault Check front bumper. E4xx Left wheel off the ground Place robot on ground. E5xx Left wheel off the ground, left collision switch fault Place robot on ground and check front bumper. E6xx Left wheel off the ground, right collision switch...

03AugAugust 3, 2015

Why did my RolliBot start cleaning again during a time that I did not schedule it?

Your RolliBot has an auto-recharge and resume feature. If the robot needs to recharge before it completes cleaning your house, it will go back to the charge base to charge. Once it is charged, it will automatically go back to finish where it left off. So while it may seem like it has started when you have not schedule it, it is actually just going back to finish the job.

03AugAugust 3, 2015

What floor surfaces can RolliBot vacuum?

Your RolliBot robot can clean all floor types including carpet, tile, laminate and hardwood floors. RolliBot will have difficulty with thick shag rugs or carpet we recommend that carpet and rug fibers be 15mm / 0.6 in or less. RolliBot may also have trouble with carpet made of synthetic fiber, even if it is 15mm/ 0.6 in or less.