Reset RolliBot BL800 to clear the error codes

If your RolliBot has a error code displayed, and it responded the remote control correctly , please follow the steps below to try a reset on RolliBot to remove the error code.

1. Using the power switch on the side to power off the RolliBot and turn it back on.

2. Hold the “CLEAN” and “HOME” Buttons at the same time until you hear an alert tone.

Press the “CLEAN” button to see if the error code is still there.

If the reset does not fixed the issue, please contact the RolliTech support team by sending an email to support@rollibot.com