Press and hold the power switch at the right of the side of the robot for more then 3 seconds. In standby mode, press clean on the main body or on off on the remote control to start cleaning. Note: If the robot is in sleep mode, press clean on the main body or on off on the remote control to wake up the robot from sleep mode. Press again to have the robot start cleaning automatically.
To set the clock with the remote control: Press button number 7 To set the clock using the buttons beneath the vacuum display: Press the button beneath the display to select MENU. Choose SET CLOCK. Using the up and down arrows, follow the onscreen prompts to set the time and day.
Using Water Tank & Mopping attachment - RolliBot BL 800 If you use the water tank kit during cleaning, please check the water tank and its mopping cloth to make sure they are being used according to the illustration above. Pay Attention to well stick the mopping cloth, avoid friction between the cloth and wheel. Water tank kit can only be used on flat floors without any sharp objects. Please don’t clean carpet, wooden floors or dry only areas with...
If your RolliBot has a error code displayed, and it responded the remote control correctly , please follow the steps below to try a reset on RolliBot to remove the error code. 1. Using the power switch on the side to power off the RolliBot and turn it back on. 2. Hold the "CLEAN" and "HOME" Buttons at the same time until you hear an alert tone. Press the "CLEAN" button to see if the error code is still there. If the reset does...
If your RolliBot has a error code displayed, and it responded the remote control correctly , please follow the steps below to try a reset on RolliBot to remove the error code. 1. Using the power switch on the side to power off the RolliBot and turn it back on. 2. Hold the "CLEAN" and "HOME" Buttons at the same time until you hear an alert tone. Press the "CLEAN" button to see if the error code is still there. If the reset does...
RolliBot keeps doing spot cleaning usually because of the dust sensor is covered by dirt, see the picture, clean up the sensor, it should work fine.
If the pitch noise is short and robot is docking fine. That is normal, it is the Rubber friction sound when the RolliBot is trying to adjust its position. If the it keeps making any kind of noise, please contact your retailer for further services.
Display Screen Display screen shows the time setting, charging status, and error codes by using numbers, letters, or graphic. Buttons 2. "Home" Auto Charging Press "HOME" button and the RolliBot BL618 will go back to its charging station to automatically charge. Press "HOME" button again or the "On/Off" button and RolliBot BL618 will stop and go into standby mode. 3. "PLAN" Schedule Button Press "PLAN" button to set up scheduled cleaning operation. Click to see schedule cleaning setup. 4. "On/Off" Clean Button A. Press this button twice...
Battery Charging A. Charging Station Placement Place charging station against the wall and remove obstacles about 1 meter (3.3 ft) at two sides and about 2 meters (6.6 ft) in front of the station, as show in figure below. Charging Station Placement - 6.6 ft clearance in front and 3.3 ft clearance to the sides Two ways to charge your RolliBot: 1. Plug the power adapter directly into the RolliBot. See Figure A below. Plug adapter into directly into RolliBot. 2. Setup charging station and press the...
Adding the Mopping attachment to RolliBot Adding Mopping Attachment to RolliBot Attach wet tissue or micro-fiber cloth to mopping holder Attach mopping holder to the bottom of RolliBot. Make sure to align the bolts and firmly press the mopping attachments into the slots on the bottom of RolliBot. If wet tissue is bigger than mopping holder, please trim wet tissue to mop holder size. Make sure the wet tissue does not rub or cover the robot wheels Be sure to turn off the UV Sterilization...
